LED Control 4

LEDControl4

LEDControl4 is connected to the 1-10 V-interfaces of the ProfiLux and outputs PWM signals, these signals can be used to control LED-lamps or LED-drivers.

Some LED-lamp manufacturers offer matching adaptor-cables for connecting their lamps to LEDControl4 an.

LEDControl4 is available in 2 variants:

LEDControl4Active – with integrated drivers

With LEDControl4Active you can dim those LED-lamps, which can be operated with a constant voltage (e.g. LED-strings which are equipped with a series resistor). LEDControl4Active doesn’t include a current controller, just the minus potential of the connected power supply is clocked through PWM! Check in any case if your LED-lamp can be operated on a constant voltage, otherwise the LED-lamp and LEDControl4Active may be damaged

 

Block diagram of the functional principle

Principle of connecting a LED-lamp

Technical Data

Permitted input voltage range 6 V … 18 V, Polarity: + inside, – outside, DC-socket 5.5/2.1 mm
Max. current per channel or in sum 3 A
Number channels 4
Input voltage range analog inputs 0 V … 10 V
PWM-switching frequency 200 Hz

You can download the datasheet for LEDControl4Active here.

 

LEDControl4Passive – without drivers

Block diagram of the functional principle

Principle of connecting LED-drivers

Technical Data:

Max. potential difference at the outputs 24 V
Max. current per channel 12 mA
Number of channels 4
Input voltage range analog inputs 0 V … 10 V
PWM-switching frequency 200 Hz
Outpur: Voltage/Current
Iout Uout [typ.]
4 mA 0,31 V
6 mA 0,42 V
8 mA 0,53 V
10 mA 0,65 V
12 mA 0,98 V

You can download the datasheet for LEDControl4Passive here.

Using LEDControl4Passive ProfiLux is able to control LED-lamps from Pacific Sun. The needed adaptor cable can be purchased from Pacific Sun. Use all the unique illumination  and simulation features of your ProfiLux with LED-lamps from Pacific Sun!